Take outa a Litle peace of a wall
Hi 
now when i finaly can start Mapping i want to make a Hole in a wall from the room She... come from 
like this
******************
******************
******************
******************
******************
******************
******************
******************
This is the wall no but i want a litle hole in it like this
******************
******************
******************
***----------------***
***----------------***
***----------------***
***----------------***
******************
What tool to use? thx
or like a door or some thing
EDIT!!!! And i get som undo warning all the time why? look here
[img]http://files.uploadffs.com/fa4f90_dontreadthefilenamesuckerxd.bmp[/img]
The undo warning just means you have the max undo amount really high.
If I remember right, you should create another brush the size of the hole, and put it inside the large brush then go to tools>carve.
Ok but my undo level is at 5 i cant get it lower caus when i get tat warning whole hammer laggs
EDIT!!!!!
Where to find bruch tool or is it block tool?
Can't you disable the warning? Or install more RAM 
.
You create brushes with the block tool. But use the carve tool cautiously. Simple box-shaped brushes should be fine to use in most cases, but if you carve with more complex brushes, they are likely to cause errors or really bad cuts.
Another way to make the hole in the wall is creating four brushes and place them like this:
- Code: Select all
111222333
111 333
111 333
111444333
ok... dont realy get it but.. iw will try to understand XD i only got 1.512 Gb RAM but its the FU** steam thet take like 100mb of it
EDIT!! here is a pic
http://files.uploadffs.com/3dcb3b_yousuckandimleet.bmp
Where the crusior (?) is i want the hole XD but the whole wall is being marked.....
Split the red wall in the picture with the cutting tool (click the button three times).
1 ) Split the red wall at the left side of the hole you're about to make
2 ) Splite the red wall on the right side of the hole you're about to make.
The red wall should now be devided into three brushes.
3 ) Select the brush in the middle.
4 ) Split that brush where you want the top of the hole to be.
5 ) Delete the brush where you want the hole and voil?! 
i dont have the cutting tool ?
Edit!!
i see that it is a addon / plugin for maya ? do this work can you compile it and stuff? cuz i got maya but not installed and im pritty good at that program
Um... It's the Clipping Tool. It looks like a cube with the top cut off diagonally.
Look at the pic a attached to this.
[...]
Yes, I meant the clipping tool. Sorry about that. Splitx, since you're new to Hammer, go here: new-to-mapping-never-used-hammer-before-look-here-t1024.html
I also saw in your picture that you have snap to grid set to 64 units!! (It's in the lower right corner of the screen)
You'll want to lower it down to about 4 or 8 by pushing '['. You can raise it again by pushing ']'.