Compile not successful? No .prt?
33 Posts
Posted Nov 23, 2013
OK, so I made a new map in Hammer and upon trying to compile it, Hammer said "Could not load "map.prt"... Any help on this?
Registered users don’t see ads!
Register now!
671 Posts
Posted Nov 23, 2013
Replied
2 hours
later
I want to see the whole compile log.
33 Posts
Posted Nov 23, 2013
Replied
18 minutes
later
Ahh sorry I figured out the problem (just a leak) but here you go anyway.
1,080 Posts
Posted Nov 23, 2013
Replied
10 hours
later
Entity light (70.44 82.09 -215.00) leaked!
33 Posts
Posted Nov 24, 2013
Replied
11 hours
later
iWork925 wrote:
Entity light (70.44 82.09 -215.00) leaked!
Yeah that was kinda sad that I couldn't figure it out.
630 Posts
Posted Nov 24, 2013
Replied
3 hours
later
Map -> Load Pointfile.
Now you should see where the leak in your map is.
33 Posts
Posted Nov 24, 2013
Replied
1 hour
later
TheTobbell wrote:
Map -> Load Pointfile.Now you should see where the leak in your map is.
That's what that does? I never knew so I never touched it. Nifty!
630 Posts
Posted Nov 24, 2013
Replied
46 minutes
later
Entity leak means that (most of the time) the light can somewhere touch the void.
And if you klick on Load Pointfile, a red line appears and shows you wheres the leak.
And if you klick on Load Pointfile, a red line appears and shows you wheres the leak.
33 Posts
Posted Nov 24, 2013
Replied
2 hours
later
TheTobbell wrote:
Entity leak means that (most of the time) the light can somewhere touch the void.
And if you klick on Load Pointfile, a red line appears and shows you wheres the leak.
Huh! Neat. What does 'Load Portalfile' do then?
630 Posts
Posted Nov 24, 2013
Replied
5 minutes
later
Load Portalfile shows the visleafs. ^^
Registered users don’t see ads!
Register now!
33 Posts
Posted Nov 24, 2013
Replied
2 minutes
later
Ah, ok. This is all starting to make sense!