Acid texture
409 Posts
Posted Jun 23, 2011
Heya there,
I have nearly finished my first level. (just got a few bits and bobs to do). However, when trying to put some toxic acid into my level, via a block with the toxic acid texture, and a trigger box inside it.
The only thing is, the trigger box works to kill the player, but the acid texture does not want to display when the map is run.
I know it's not down to my lighting source as my gel renders perfectly on the map.
What could cause this?
Registered users don’t see ads!
Register now!
39 Posts
Posted Jun 23, 2011
Replied
35 minutes
later
Only the top side should have toxic texture, the others must be nodraw.
238 Posts
Posted Jun 23, 2011
Replied
3 minutes
later
Have the brush covered in nodraw texture and only apply the texture to the top. (make sure it's not a cheap or vertex texture or w/e).
Also make sure you placed a env_cubemap and a water_lod_control.
2,460 Posts
Posted Jun 23, 2011
Replied
1 minutes
later
Compile Vrad and VVis so it can draw the water too.
409 Posts
Posted Jun 23, 2011
Replied
27 minutes
later
I found out what was causing the problem. For some reason I had two trigger boxes in the same place, even though I created one. I deleted the acid texture box and created it again, now it works. =]
Registered users don’t see ads!
Register now!
76 Posts
Posted Jun 23, 2011
Replied
4 hours
later
Lostprophetpunk wrote:
I found out what was causing the problem. For some reason I had two trigger boxes in the same place, even though I created one. I deleted the acid texture box and created it again, now it works. =]
Hoorah:)