Home-built CNC playing "Still Alive" on its motors
1 Posts
Posted Feb 05, 2013
Hi there.
I've been a long-time lurker on TWP and the avid Half-Lifer since the very early days...
I've registered to share a link to a video, where my friend's home-built CNC cutter plays "Still ALive" tune by varying the speed of its motors and engaging different motors at precisely programmed moments. It probably does not get closer to experience how GLaDOS would have played it...
So, without further ado:
http://www.youtube.com/watch?v=mrMtHbbtRB8
I've been a long-time lurker on TWP and the avid Half-Lifer since the very early days...
I've registered to share a link to a video, where my friend's home-built CNC cutter plays "Still ALive" tune by varying the speed of its motors and engaging different motors at precisely programmed moments. It probably does not get closer to experience how GLaDOS would have played it...
So, without further ado:
http://www.youtube.com/watch?v=mrMtHbbtRB8
Registered users don’t see ads!
Register now!
2,460 Posts
Posted Feb 05, 2013
Replied
2 hours
later
This reminds me of that laser cutter that played still alive.
Whyyyyyyyyyyyyyyy
1,442 Posts
Posted Feb 06, 2013
Replied
10 hours
later
ChickenMobile wrote:
This reminds me of that laser cutter that played still alive.Whyyyyyyyyyyyyyyy
Reference:
Registered users don’t see ads!
Register now!
4,136 Posts
Posted Feb 06, 2013
Replied
10 hours
later
So this is completely unrelated sort of, but can you tell me about the CNC? Me and a friend are in the early stages of building one and I'm trying to absorb as much information as I can.